Search found 6 matches
- Sun Jan 12, 2020 5:19 pm
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
Re: ID tower
Thanks to all!
- Wed Jan 08, 2020 6:05 pm
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
Re: ID tower
Yes, the flat steel step would be hard on the feet but men were men back then,with hard boots! lol
Thanks again to everyone for the help.
Thanks again to everyone for the help.
- Wed Jan 08, 2020 4:08 pm
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
Re: ID tower
Here are two photos...one of the braid end and the other of the ladder.
Had a e-mail from Issiaih Yott of the Kregel windmill factory museum he thought it looks as if it could be a ELI Tower. Any thoughts?
Thanks
Had a e-mail from Issiaih Yott of the Kregel windmill factory museum he thought it looks as if it could be a ELI Tower. Any thoughts?
Thanks
- Wed Jan 08, 2020 8:25 am
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
Re: ID tower
Thanks to everyone for the help. The tower does not have the cap but I will post pic of the wire and ladder.
Later today.
Later today.
- Sun Jan 05, 2020 1:40 pm
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
Re: ID tower
The mill appears to be a double gear Butler. Not sure this tower fits the Butler. Could it be a early Dempster?
Thanks
Thanks
- Sat Jan 04, 2020 4:04 pm
- Forum: Name That Part (or Windmill or Tower)
- Topic: ID tower
- Replies: 38
- Views: 14822
ID tower
Good evening. I just joined site and was hoping someone would help ID this tower?
Any help would be appreciated.
Trying to ID this tower. 20 feet tall, 2.5 inch angle supports, braided wire support.
Any help would be appreciated.
Trying to ID this tower. 20 feet tall, 2.5 inch angle supports, braided wire support.
