Babbitt Bearings Pouring Video

[JBarker]

Here is a good babbitt bearings pouring video. Even though it's not on a windmill, it still was educational. Thanks.

[Jim Corcoran]

Jerry,
Thanks for posting this. Very informative for someone who has never done this. If I had anything that used babbitt bearings, I'd give it a try.
Regards,
JIm

[JBarker]

Jim,

Your welcome. Did you get that tower up yet? Thanks.

Jerry

[Jim Corcoran]

Not yet. I disassembled it for storage. In the process of restoring the Monitor V that will go on it.
Jim

[Bryon]

I have been watching Keith Rucker's videos for the last few years. He is very informative. If you like seeing machinist work, this is a good "channel" to watch.

[mtblah]

Jim, if you ever need help pouring babitt I have all the "stuff " required. I poured my A702 bearing , only took 4 attempts , but that windmill is up and spinning now. It was a FUN experience.
I would be glad to help.
Mike B
New Braunfels TX

[Jim Corcoran]

if you ever need help pouring babitt I have all the "stuff " required.

Mike,
Thanks for the offer. I'll take you up on it if the opportunity arises.
Thanks again and best regards,
Jim

[JBarker]

Here's another video on babbitt pouring by Keith Rucker on a sugar cane mill. The principles are the same for windmills. Jerry

[Kenneth]

I am trying my hand at babbit pourings on my Red Cross.
I will have to get a few things but I am willing to learn. Like they say, if it's not right melt it out and try again.

Kenneth

[Kenneth]

Is there anything wrong with using used Babbitt. I have some old and some new. I believe AJ Woodack mentioned he used 1/2 used and 1/2 new. Any comments?

Kenneth