Aermotor blades
Aermotor blades
Fixing up an 8ft aermotor wheel. The new bottom clips are a little taller than originals. Has anyone ran into same issue and is it a problem with blade pitch?
You do not have the required permissions to view the files attached to this post.
Last edited by Russail on Fri Dec 09, 2022 8:30 am, edited 1 time in total.
Re: Aermotor blades
Are the holes in the same place?
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
-
Windcatcher530 Dan
- Posts: 2207
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Aermotor blades
I don't believe the height would change the pitch but the angle would.
Re: Aermotor blades
Holes match up
-
Windcatcher530 Dan
- Posts: 2207
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Aermotor blades
If the holes line up not a problem Russail.
Re: Aermotor blades
I agree.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
