Windmill Barn
Re: Windmill Barn
Hyatt bearings. Ifg I remember, they were in seperate carriers, bolted to the mainframe. I converted one from Hyatt to Babbitt one time. Dug the Hyatts out of the carriers, and poured those with babbitt. Also installed grease zerks. There was like 9 or 11 of them or something like that. Just say a bunch.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
-
Windcatcher530 Dan
- Posts: 2205
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Windmill Barn
You're right about that windy Bob mine has babbitt and I still remember when me and my brother poured the bearings and it was a bunch,i believe it took us most of the day.
-
Windcatcher530 Dan
- Posts: 2205
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Windmill Barn
I figured I'd put my old corn chopper,sheller and planter on the porch of the barn.
You do not have the required permissions to view the files attached to this post.
Re: Windmill Barn
Dan , it does look like you need several of those "table tops " to match your furnishings .
Re: Windmill Barn
Neat Stuff Dan!
Re: Windmill Barn
Very nice Dan. Very nice
-
Windcatcher530 Dan
- Posts: 2205
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Windmill Barn
Well I've been able to get a little bit more done. The weather hasn't been that bad no snow mid thirties so i built some stands on casters and a hinge for the Stover tower.
You do not have the required permissions to view the files attached to this post.
Re: Windmill Barn
Looks good Dan. Will you have enough head room to stand it with the wheel?
-
Windcatcher530 Dan
- Posts: 2205
- Joined: Sun Mar 28, 2021 4:06 pm
- Location: Alcove N.Y.i buy and restore
Re: Windmill Barn
Yes I will Mark with 2 inches to spare !!!
Re: Windmill Barn
Your propane heater should make your "barn" tolerable in mid 30's weather
