Dempster Identification?
Dempster Identification?
The only part I have of our Dempster is the ShortTailed horse with the 58 cast on the side, I see some that show 58C, it is hard to tell if there could have been a C on this horse. Maybe that helps to date it? I'll attach some photos from the 1943 era when the windmill was still complete. Photos from 1951 show that the mill was missing then. The fans on this mill have 13 slats, I see some photos online and can count 12, 13, or 14 slats with 13 as the most common. Do the number of slats identify if it was a 10 or 12 foot? Can it be determined if it is a #3, #4, or #14 from these photos?
You do not have the required permissions to view the files attached to this post.
-
Challenge 27
- Posts: 50
- Joined: Fri Jan 04, 2019 4:19 pm
Re: Dempster Identification?
The six section wheel was used for the 10 foot size. 12 footers used an 8 section wheel.
After looking at the photos, I'm thinking its more likely a #3.
Getting a #3, restored or otherwise, shouldn't be too much of a problem, they were a common windmill at one time. Probably could get one at the Trade Fair in Poteet in September.
Challenge 27
After looking at the photos, I'm thinking its more likely a #3.
Getting a #3, restored or otherwise, shouldn't be too much of a problem, they were a common windmill at one time. Probably could get one at the Trade Fair in Poteet in September.
Challenge 27
Re: Dempster Identification?
Check with Dan Benjamin for parts including a wood kit.
Re: Dempster Identification?
Dempster #1 and #2 mills had long tailed horses. Dempster #3, #4 and #14 had short tailed horses. So says the bible.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Dempster Identification?
I have another question about this old windmill tower. Can you determine how tall it is from the pictures? It was taken down in my teenage years, I remember climbing it. But I would be guessing how tall it was.
Re: Dempster Identification?
Neat photos. Welcome to the forum.
Counting the ladder steps between each cross girt, there appears to be about 3 ladder steps between each. Guesstimate at 18” between each ladder step, would put it about 30’ +/-. I could be way off…
Other old towers that I have or I’ve seen are typically in 10 foot increments.
Counting the ladder steps between each cross girt, there appears to be about 3 ladder steps between each. Guesstimate at 18” between each ladder step, would put it about 30’ +/-. I could be way off…
Other old towers that I have or I’ve seen are typically in 10 foot increments.
-
Minnemiller
- Posts: 89
- Joined: Mon Dec 17, 2018 9:14 pm
- Location: Elko New Market, MN
Re: Dempster Identification?
I read your other post before this one. Definitely a 10ft Dempster no. 3. It is a 10ft since it has 6 sections. The good news is it's the most easily found of the Dempster vaneless mills so you should be able to buy one. That doesn't mean they are very common but a collector may have a spare one they would part with.
