Diverter cup

[CTXmiller]

Any chance this is an Aermotor diverter cup with the A102 casting? I only took a photo of the bottom of it, but could take additional photos tomorrow. I don’t see a 102 on any Aermotor parts list that I have and I know an “A” is generally associated with 8’.

[windybob]

I wonder if that would be on a tower, or mill parts list....

[Windcatcher530 Dan]

I checked my litterateur this is all I could find.

20231231_125528_Burst01.jpg

[CTXmiller]

It is probably not then, looking at what you posted. I’m still curious what an Aermotor part # 102 actually was. Thank you.

[mtblah]

Michael , if your snout bowl has threaded outlet I would say it is an Aermotor , your photo & catalogue appear the same .

[Ron Stauffer]

My first glance at the casting number.did not look like Aermotor because of the style type and font of the casting. I have 4 catalogs with the casting number of 233 on spout cup

20240102_220926.jpg

A prefixes on aermotor parts were only for the 8 motors. Pump parts had a p and tower parts had a t. There was never any 8 foot motor part in open gear or oil Bath that was 102. 101 was the closest being a sale rib and then a jumped to over 110. I have a special catalog of pipe and fittings by aermotor but it is not in there

Ron Stauffer
Montrose CO

[CTXmiller]

Thank you