Happy birthday
Happy birthday
Happy birthday Peter!
Re: Happy birthday
Happy Birthday, youngster. lol
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Happy birthday
Happy Birthday Peter
-
Ron Stauffer
- Posts: 540
- Joined: Fri Dec 14, 2018 10:25 am
- Location: Uncompahgre Plateau Montrose CO
- Contact:
Re: Happy birthday
Am sure he has those Aussie mills corrected for proper wheel rotation north of the equator but no pictures, eh? Happy Birthday!
Ron Stauffer
Montrose CO
Ron Stauffer
Montrose CO
-
Peter vk
- Posts: 347
- Joined: Sat Dec 15, 2018 11:30 am
- Location: Chesterville Ontario Canada
- Contact:
Re: Happy birthday
Thanks for the birthday wishes everyone! 
Ron, I haven't done much with the Aussie mills yet. I did get a bunch of stuff ready to get galvanized, it will be next winters project. The picture of the Toronto wheel and tail is what I dragged home today
Peter
Ron, I haven't done much with the Aussie mills yet. I did get a bunch of stuff ready to get galvanized, it will be next winters project. The picture of the Toronto wheel and tail is what I dragged home today
Peter
You do not have the required permissions to view the files attached to this post.
-
Ron Stauffer
- Posts: 540
- Joined: Fri Dec 14, 2018 10:25 am
- Location: Uncompahgre Plateau Montrose CO
- Contact:
Re: Happy birthday
So are going to fix today's treasure or sell pats/ You know what the next question is!
Ron
Ron
-
Peter vk
- Posts: 347
- Joined: Sat Dec 15, 2018 11:30 am
- Location: Chesterville Ontario Canada
- Contact:
Re: Happy birthday
Ron, if you want a Canadian Airmotor tail for a wall hanger this one is okay on one side, the other side has two rust patches from laying on the ground. I'm keeping the wheel I'm going to take it apart and re roll it.
Peter
Peter
