Aermotor Power Mill "Pump Gear" parts

fivepicker · Post by **fivepicker** » Sun Jun 02, 2024 12:01 pm

Or if anyone has a complete unit and could trace the cast parts described , I'd certainly pay for your time and postage ........

fivepicker · Post by **fivepicker** » Sun Jun 23, 2024 3:31 pm

Found One !! .......... Could still use a coupling half for 3/4" shaft

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Sun Jun 23, 2024 4:28 pm

Talk about luck, you should play the lottery!!

fivepicker · Post by **fivepicker** » Sun Jun 23, 2024 4:56 pm

Well , .... really wasn't much luck involved , it was locked in these , took a lot of cutting , welding , grinding and such to get it out !!

windybob · Post by **windybob** » Tue Jun 25, 2024 3:18 pm

Now THAT"S my kind of engineer!

I've done stuff similar to that in the past, that should get me tossed in windmill jail....

fivepicker · Post by **fivepicker** » Wed Jun 26, 2024 11:09 am

Thanks , I think ........ Probably has something to do with the color of things under my collar .........

fivepicker · Post by **fivepicker** » Sat Aug 10, 2024 4:02 pm

Pretty much down to just needing the cast iron drive coupling half , for 3/4" shaft , seen here , lower left . Other two parts are about built .....

DSC_0905.JPG

windybob · Post by **windybob** » Sat Aug 24, 2024 3:52 pm

can't wait to see the end result!

fivepicker · Post by **fivepicker** » Tue Aug 27, 2024 10:15 pm

Pitman pretty much done , all but the babbit ......

DSC_0932.JPG

Windcatcher530 Dan · Post by **Windcatcher530 Dan** » Wed Aug 28, 2024 3:44 am

Really nice job,evan has the oil cup !!!

Vintage Windmill and Wind Generator Forum