Kenwood

Generally speaking, this area is for general discussion about windmills, in most cases.
Post Reply
Wayne
Posts: 2310
Joined: Mon Dec 17, 2018 10:03 am
Location: Corsicana Tx.

Kenwood

Post by Wayne »

Was at a friends yesterday. He had recently taken down a Sears Kenwood which was a Monitor WC. It was setting over a tile well. What caught my eye was when he was showing me the tank and pipe from the well was where the cylinder was mounted. It was above the water level. They had even mounted a faucet on it. About midway of the cylinder they had fasten a pipe and put A faucet on the end. The setup was made to pump into the bottom of the tank he said. I don't know if there was a pipe running up in the tank so the water actually came out at the top inside the tank. Didn't think about that until later. Has anyone else ever seen a setup like that? :D
Kansas Rust Buzzard
Posts: 582
Joined: Fri Dec 28, 2018 9:33 pm

Re: Kenwood

Post by Kansas Rust Buzzard »

All I know is the only Kenwood Monitor I ever took down had a brass tag on it saying Sears Roebuck and Co. I thought that was pretty neat.
Wayne
Posts: 2310
Joined: Mon Dec 17, 2018 10:03 am
Location: Corsicana Tx.

Re: Kenwood

Post by Wayne »

Don't know if his did he had it covered with a tarp I saw pictures of it as he took it down
Post Reply