On our A602 tail arm where the spring hooks I see several holes I assume it's for some type of adjustment.
Probably a dumb question but I am learning more all the time from this forum and love all the knowledge passed down.
Thanks everyone
Have a better New Year
Tail holes
Re: Tail holes
Yes they are. The way we set tension, is to install the spring to where the tail is open, and the spring is just tight enough so it doesn't fall off. That will enable the wheel to furl early in the wind.
The tighter the spring, the more wind it takes for the mill to furl out of the wind.
The tighter the spring, the more wind it takes for the mill to furl out of the wind.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: Tail holes
Thanks for the information
I thought that was what they are for.
Again thanks
I thought that was what they are for.
Again thanks
Re: Tail holes
yessir.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
