Dandy Parts

[Wayne]

Looking for the Pull-out Sleeve parts. D22,D23,D24 I need it all but figure I could make the D51 Pull-out Yoke.
(03-571-0865 will take text, axtellstandard@gmail.com

[Wayne]

Found I have some of the parts. I have two yokes and the parts Ided as D23 and D24. Except my parts are both 941.

[windybob]

Would that be for a 6 or 8 ft mill?

I have learned that There are more of these mills in Tx than most places.

[Wayne]

It is an 8 ft. Windy you are right about there being a lot of Dandy's in Texas. I have found 4 within about 30 miles of me. The tower I have came from a farm about 10 miles away. At sometime someone had cut the head off with a cutting torch. I'm wondering if it was done during the scrap iron drives of WW2. Makes me think we had a Dealer in Corsicana. There is another complete tower laying on the ground in a little town of Penelope about 30 miles away. Been there so long grass has grown over the lower legs. Not for sale. I guess they are waiting for it to sprout a new one. I have decided if I can't find these parts I may see if the same type set up from a Monitor WC will work. In the parts list they look close to the same.

[windybob]

Whatever happened to Chuck at the Windmill Farm? I remember he had Dandy parts.

[Wayne]

I have his Dandy Parts. Went up there one time and he gave them to me. I don't know about him and Ruby. Think I will call Steve Adams who lives out in the area and see what he knows. An Axtell Standard vane came up on Craigslist and the man selling it said he had bought it from Chuck.

[windybob]

Ok. I can't believe they wouldn't know about the website change by now. Maybe they're just busy all the time, or sidelined for a while. I certainly know how that is....

[Bryon]

Chuck has been on here. He is "Windmill Farmer". Hasn't been on for a while. I don't know what they are up to (He and Ruby).

[windybob]

Thanks Bryon.

[Wayne]

Instead of wondering maybe I should call him.