Smith & Pomeroy - Eureka Steel

[IvanBlock]

About six weeks ago I found an 8' back geared Eureka Steel in close to complete condition. It had been rolled back and forth across the farmyard several times over the years so its gotten pretty banged up. Being as scarce as it is I've decided to make it one of my winter projects. The only other thing Eureka I found over the past 25 years was a tailvane and an 1895 original catalog. It has a couple of broken castings, missing pinion gear, mast pipe broken off flush with the frame (the mast pipe on these was cast into the main casting so that will have to be removed) and a hub that is totally trashed. Everything but the hub I'm able to handle but can anyone offer a suggestion on how to replicate that hub. The chances of finding parts or another hub to recast from is probably zero. Any ideas on getting that pipe out of the frame, 13" total with a 1 1/2" pipe, pretty hard to get a torch tip in vary far. Any help, ideas, pictures, parts list would be helpful. Attached are some pictures.

101_0184.JPG

101_0185.JPG

101_0194.JPG

101_0193.JPG

101_0210.JPG

101_0209.JPG

101_0191.JPG

[mtblah]

Ivan , great find !
The hub you have has a good origional section remaining , a pattern maker can use that and replicate that into a complete circle .
Just time & money

[Windcatcher530 Dan]

Ivan can you cut off a couple of inches off the mast pipe up in the head of the mill and slip a new one in and weld it to the mill

[Windcatcher530 Dan]

Ivan a friend of mine who's son works with a 3D printer believes he could take your broken hub and replicate it.Then you could use it to cast a new one

[steve p]

Great find Ivan. Good luck with the restoration. Interesting project.

[Les Jacox]

Ivan, this is our Eureka. If the hub will work for you, I'll get if off and you can recast it. Let me know.

DSCN2481a.jpg

DSCN2483a.jpg