ID WINDMILL MANUFACOTOR

[CABBOTT]

I was hoping that someone may be able to help identify the type of windmill head I have. The only marking on it are WAA1C1 which is on the side and on top of the head is" USE MEDIUM ZERO OIL" I have attached 3 photos, sorry I could not reduce the size of the photos any more than I have.

[CABBOTT]

Additional pictures to support the ID of the windmill, could not get them on first posting.
Thanks Chester

[CABBOTT]

Additional pictures to support the ID of the windmill, could not get them on first posting.
Thanks Chester

[windybob]

Chester, you can make another post for more pictures. Only so many fit on a post.

I think I know what that is, but need a wider shot if you can.

[CABBOTT]

Thank You for the response.

SAM_2136.JPG

SAM_2136.JPG

I have been trying to get more photos upload on this issue. I'm trying again now to see if I can upload additional photos.

[windybob]

That's a Fairbanks Morse worm Gear (WG) mill made in the 30's. They sold scads of those things.

[CABBOTT]

Thanks Bob, I will see if parts are available for it.
Regards Chester

[windybob]

New parts, no. Used parts, should be available. I have several 8 footers.

[CABBOTT]

Bob, I'm going to try and tare down the WG today and see what parts I need for the head. Right now having trouble pulling the hub of the drive shaft. Thanks for the support.
Regards Chester

[windybob]

Pulling a hub can be near impossible. Might be easier to find what holds the worm gear on the shaft, and maybe slide it out.? Never had one apart yet. Take notes. Take pictures. Take you time! Be patient.

Not sure where exploded view pictures are. You might check the library section to see.