ID help
Re: ID help
It sure looks pretty close, hard to get a good picture right now. I will wait till later and try to duplicate the same angle
You do not have the required permissions to view the files attached to this post.
Re: ID help
Thanks everyone for your help. At this time the owner is deciding what he wants to do. He asked me if I would rebuild it for him and I declined. He has no other parts other that what you see in the pictures I have posted. He wants a windmill to spin and this one would require too much work and then there the issues of lubrication once it is in use. I have suggested he look for an Aermotor or other run in oil type windmill that is complete with a tower.
Again, thanks for the help!
Again, thanks for the help!
Re: ID help
It was fun looking and waiting for the expert's to figure it out.I never had any doubt.
-
Aermotor Fan
- Posts: 41
- Joined: Sun Apr 28, 2019 8:04 pm
- Location: southeastern Wisconsin
Re: ID help
a Stover Freeport mill I never heard of that mill before.
Adam
Adam
Re: ID help
Made for 3 years, give or take. 1890's. It's referenced in the green book under Stover. Look in the back of the 'bible'. it's also referenced in the back of it.
Call Dan Benjamin for parts. P M me for the phone number. IF YOU TALK TO HIM, AND HE HELPS YOU, THEN BUY FROM HIM. IT CREATES GOOD KARMA.
Re: ID help
Well it looks like the Stover Freeport is going back to Cali next week. The owner has a friend that wants to help him with it. Thanks everyone for your help in the identification.
Jeff
Jeff
